Audio-Technica AT-VM95C/H Phono Cartridge
VM95 series Conical stereo cartridge on AT-HS6 Headshell.
AT-VM95C mounted on AT-HS6BK headshell
The total set weight is 15.5g
Assembled and tested in the Audio-Technica Factory in Fukui-Japan
VM95 series Conical stereo cartridge on AT-HS6 Headshell.
AT-VM95C mounted on AT-HS6BK headshell
The total set weight is 15.5g
Assembled and tested in the Audio-Technica Factory in Fukui-Japan
VM95 series Conical stereo cartridge on AT-HS6 Headshell.
AT-VM95C mounted on AT-HS6BK headshell
The total set weight is 15.5g
Assembled and tested in the Audio-Technica Factory in Fukui-Japan
VM95 Series - Styli Compatibility
Every cartridge diamond stylus becomes worn after a period of play.
Around 500 hours for a conical stylus, 300 hours for an Elliptical stylus, 1000 hours for a Microlinear stylus, and 800 hours for a Shibata stylus.
Our VM95 Series dual moving magnet cartridges can be used almost forever by replacing the interchangeable stylus. It is no longer necessary to purchase a complete cartridge when your diamond is worn out, you can simply buy the matching replacement stylus, but also enjoy the experience of upgrading your cartridge with a different stylus.
The six models of VM95 Series cartridges all use the same electromagnetic engine-body, therefore each of the six replacement styli are perfectly compatible.
AT-VMN95C / AT-VMN95E / AT-VMN95EN / AT-VMN95ML / AT-VMN95SH / AT-VMN95SP
Conical Bonded Stylus
The benefit of conical styli, even if the cartridge is "lean”.
-
Frequency Response: 20 - 20,000 Hz
Channel Separation: 18 dB (1 kHz)
Vertical Tracking Angle: 23°
Vertical Tracking Force: 1.8 to 2.2g (2.0g standard)
Stylus Construction: Bonded Round Shank
Recommended Load Impedance: 47,000 Ω
Coil Impedance: 3.3 kΩ (1 kHz)
DC Resistance: 485 Ω
Coil Inductance: 550 mH (1 kHz)
Output Voltage: 4.0 mV (@ 1 kHz, 5 cm/sec)
Output Channel Balance: 2.5 dB (1 kHz)
Stylus Shape: Conical
Cantilever: Aluminium Pipe
Static Compliance: 17 x 10 – 6 cm / dyne
Dynamic Compliance: 6.5 x 10 – 6 cm / dyne (100 Hz)
Mounting: 1/2” centres
Cartridge Weight: 15.5 g
Dimensions: 21.2 × 21.4 × 62.4 ( H x W x D mm)
Accessories Included: Two 11 mm installation screws; Two 8 mm installation screws; Two washers
Model: AT-VM95C/H
Recommended Load Capacitance: 100-200 pF
Replacement Stylus: AT-VMN95C
Stylus Size: 0.6 mil
Type: VM Stereo Dual Magnet
Wire Used for Coil: T.P. Copper
